SERVICE MANUAL NUMBER 22
STERNDRIVE (MCM) MODELS
Page 2A-18 90-860074--1 FEBRUARY 2002
8. Connect the trim position sender bullet connectors, from the gimbal housing, to the
engine harness.
24841
BLK/WHT
BLU/BLK
BLK
BLK
a
b
a-From Engine Harness
b-From Gimbal Housing
9. Mount the gear lube monitor in the engine bracket. Secure with strap.
10. Connect gear lube monitor wires to corresponding engine harness wires. The TAN/BLU
wire connects to ORANGE engine harness wire. BLACK wire connects to BLACK wire.
Ensure that bullet connectors are fully seated.
75301
a
b
c
Typical
a-Gear Lube Monitor
b-Strap
c-Bullet Connectors
To Next Page
Loading...
