INBOARD (MIE) MODELS SERVICE MANUAL NUMBER 22
Page 2B-20 90-860074--1 FEBRUARY 2002
5. After all wires are connected secure them with clamps or tie straps, which may have
been retaining them to engine or hoses prior to removal.
6. Connect exhaust elbow, riser or water lift muffler, if equipped, to exhaust system hose
using at least two hose clamps at each connection. Tighten hose clamps securely.
7. Connect seawater inlet hose to seawater pump connector fitting. Tighten hose clamp
securely.
75299
a
b
Typical
a-Seawater Inlet Hose
b-Connector Fitting
8. If removed previously, connect seawater inlet hose to seawater strainer and tighten
hose clamps securely.
71362
a
b
c
a-Seawater Inlet Hose
b-Seawater Strainer
c-Hose Clamps (2)
To Next Page
Loading...
Need help?
General