ENGINE MECHANICAL
SERVICE MANUAL NUMBER 22
90-860074--1 FEBRUARY 2002 Page 3A-131
5. Rotate all bearing carriers so that the ROUND hole through the casting faces as shown,
toward oil pan flange. Ensure that piston oil jets are directed toward FRONT of engine.
70434
a
a-Bearing Carrier ROUND Hole
6. Install new sealing washers on all main bearing carrier locating hollow bolts and HAND
THREAD CAREFULLY (to avoid damaging carrier threads) into bearing carriers. Where
previously noted, install locating bolt for oil sending unit (after removing sending unit and
adaptor nozzle from bolt, to allow torquing). Torque all bolts to 53.9 Nm (39 lb-ft).
70386
a
b
b
a-Carrier Locating Hollow Bolts
b-Sealing Washer(s)
7. Reinstall adaptor nozzle and oil sending unit on special locating screw. Tighten both
securely.
To Next Page
Loading...
Need help?
General