ZF / HURTH TRASNSMISSIONS SERVICE MANUAL NUMBER 22
Page 8A-18 90-860074--1 FEBRUARY 2002
6. Place remote control shift lever in forward gear position. Ensure transmission is fully in
gear, as follows:
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
d. Temporarily install shift cable. Do NOT secure at this time.
7. Place remote control shift lever in reverse gear position. Again ensure transmission is
fully in gear as follows:
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
d. Temporarily install shift cable. Do NOT secure at this time.
8. Follow instructions a. or b. :
a. If transmission shift lever will position properly in one gear, but not in the other, re-
check shift cable adjustment.
b. If transmission shift lever will not position properly in both gears, move transmission
shift lever stud from top hole in shift lever to bottom hole and recheck for proper posi-
tioning. If proper positioning is still not obtained, the remote control does not provide
sufficient shift cable travel and must be adjusted, repaired or replaced. Refer to
manufacturer’s instructions.
50228
a
b
c
a
a-Shift Lever Stud (In Bottom Hole, If Required)
b-Lever, In Neutral Detent, Must Be Approximately 10 Degrees Of Vertical
c-Shift Lever Top Hole
9. Install nut and washer to cable end guide stud. Tighten until contact, then loosen 1/2
turn.
10. Install nut and washer to cable barrel stud. Tighten until contact, then loosen 1/2 turn.
To Next Page
Loading...
Need help?
General