Micom P631 - Page 304

Parameter Address
Default Min Max Unit Logic Diagram
Device
DVICE: Device type
000 000
631 631 762
[spacer]
The device type is displayed. This display cannot be altered.
[spacer]
DVICE: Software version
002 120
Not measured 0.00 655.35
[spacer]
DVICE: Software version 6XX
010 167
Not measured 0 65535
[spacer]
DVICE: Software version 7XX
010 168
Not measured 0 65535
[spacer]
Software version for the device. This display cannot be altered.
[spacer]
DVICE: SW date
002 122
01.01.97 01.01.97 07.11.98 dd.mm.yy
[spacer]
Date the software was created. This display cannot be altered.
Note: The centuries are not displayed. The supported dates range from January
1st, 1997, until November 7th, 2098.
[spacer]
DVICE: SW version communic.
002 103
Not measured 0.00 655.35
[spacer]
Software version for the device's communication software. This display cannot
be altered.
[spacer]
DVICE: DM IEC 61850 version
002 059
Not measured 0 65535
[spacer]
Software version of the communication software based on the device's protocol
per IEC 61850. This display cannot be altered.
[spacer]
DVICE: Language version
002 123
0.0 0.0 899.9
[spacer]
Identification of the change level of the texts of the data model. This display
cannot be altered.
[spacer]
DVICE: Text vers.data model
002 121
0 0 255
[spacer]
Using the ‘text replacement tool' provided by the operating program, the user
can change the parameter descriptors (plain text designations) and load them
into the device. These customized data models contain an identifier defined by
the user while preparing the data model. This identifier is displayed at this point
in the menu tree. Standard data models have the identifier ‘0' (factory-set
default).
[spacer]
DVICE: F number
002 124
0 0 9999
[spacer]
The F number is the serial number of the device. The display cannot be altered.
P631
7 Settings
7-4 P631/EN M/R-11-C // P631-310-650