Micom P631 - Page 320

Parameter Address
Default Min Max Unit Logic Diagram
[spacer]
COMM1: Select. spontan.sig.
003 179
060 000: MAIN: Without function Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
Selection of spontaneous signals for transmission via “logical” communication
interface 1.
[spacer]
COMM1: Transm.enab.cycl.dat
003 074
0: Without Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
Enabling of cyclic transmission of measured values via the communication
interface.
Note: This setting is hidden unless an IEC 870-5 protocol is enabled.
[spacer]
COMM1: Cycl. data ILS tel.
003 175
060 000: MAIN: Without function Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
Selection of the measured values that are transmitted in a user-defined
telegram via the communication interface.
Note: This setting is hidden unless an IEC 870-5 protocol is enabled.
[spacer]
COMM1: Delta I
003 051
3.0 0.0 15.0 %Inom Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
A measured current value is transmitted via the communication interface if it
differs by the set delta quantity from the last measured value transmitted.
Note: This setting is hidden unless an IEC 870-5 protocol is enabled.
[spacer]
COMM1: Delta meas.v.ILS tel
003 150
3.0 0.0 15.0 Fig. 3-7, (p. 3-12)
Fig. 3-8, (p. 3-13)
Fig. 3-9, (p. 3-14)
[spacer]
The telegram is transmitted if a measured value differs by the set delta quantity
from the last measured value transmitted.
Note: This setting is hidden unless an IEC 870-5 protocol is enabled.
P631
7 Settings
7-20 P631/EN M/R-11-C // P631-310-650