Version Changes
DVICE The previous parameter DVICE: Order No. (000 001)
has been renamed to DVICE: AFS Order No. (001
000).
LOC The parameters (005 251) and (080 110) have been
renamed to LOC: Fct. reset key (005 251) and LOC:
Fct. read key (080 110) without any changes in their
functionality.
Now the selection offered for the parameter LOC:
Language (003 020) no longer is between, e.g.
German, and English but between “Regional language”
and “Reference language”. (This will not cause any
changes in functionality as the Reference language is
US English and the Regional language will depend on
the language order option.)
IEC IEC: Deadband value (104 051) was divided into
several individual settings:
●
(104 229) IEC: Update Measurements
●
(104 230) IEC: Dead band IP
●
(104 231) IEC: Dead band IN
●
(104 232) IEC: Dead band VPP
●
(104 233) IEC: Dead band VPG
●
(104 234) IEC: Dead band f
●
(104 235) IEC: Dead band P
●
(104 236) IEC: Dead band phi
●
(104 237) IEC: Dead band Z
●
(104 238) IEC: Dead band min/max
●
(104 239) IEC: Dead band ASC
●
(104 240) IEC: Dead band temp.
●
(104 241) IEC: Dead band 20mA
MAIN The following menu points are now available for each
parameter subset:
●
MAIN: Vnom prim. end a PSx
●
MAIN: Vnom prim. end b PSx
The parameter (003 030) has been renamed to MAIN:
Device on-line.
Note:
These signal assignment parameters are visible in the
data model for 4 circuit breakers. However, they are
not implemented for the P631.
MEASI The result of the temperature measurement may now
also be read out as the maximum value since the last
reset operation (temperature T
max
).
A5 P631 Version History
P631
P631/EN M/R-11-C // P631-310-650 A5-15
To Next Page
