Micom P631 - Page 634

Version Changes
Software
MEASO Scaling of the BCD coded output of measurands now
allows the setting of an output values range. This
feature is required if signed event measurands are
assigned to the BCD output (like fault location or short-
circuit reactance,…).
DVICE Instead of one parameter for the software version
(previously: (002 120) DVICE: Software version)
the version numbers -6XX and -7XX are now separately
stored in two new parameters:
●
(010 167) DVICE: Software version 6XX
●
(010 168) DVICE: Software version 7XX
PC, DVICE It is now possible to upload new firmware to the device
via TCP/IP protocol. For this purpose there are several
new network setting parameters that are not identical
to the ones already existing within function group IEC:
●
(111 004) PC: IP address
■
(111 005) PC: IP address 1
■
(111 006) PC: IP address 2
■
(111 006) PC: IP address 3
●
(111 008) PC: Subnet mask
■
(111 009) PC: Subnet mask 1
■
(111 010) PC: Subnet mask 2
■
(111 011) PC: Subnet mask 3
●
(111 016) PC: IP address mode
●
(111 017) PC: IP Enable config.
Moreover, there are new information parameters which
store the actual network settings for this firmware
uploading network. These exist primarily for testing
purposes.
●
(111 000) DVICE: IP address
●
(111 001) DVICE: Subnet mask
●
(111 003) DVICE: MAC address
P631
A5 P631 Version History
A5-26 P631/EN M/R-11-C // P631-310-650