MICRO-EPSILON optoCONTROL 2600 - Page 67

Page 67
Appendix | Other Pin Assignments
optoCONTROL 2600
Pin to
controller
(HD-Sub 25)
IF2008/PCIE interface
card
Socket X1 (or X2)
15-pin
Sub-D,
IF2008
IF2008/PCIE,
X1 and X2, 15-
pin. Sub-D
Controller
ODC 1
7 Sensor 1 (3) TxD+ 2
20 Sensor 1 (3) TxD- 1
8 Sensor 1 (3) RxD+ 4
21 Sensor 1 (3) RxD- 3
24 Sync In+ 6
12 GND 15
NC 7
NC 8
NC 9
NC 10
Controller
ODC 2
7 Sensor 2 (4) TxD+ 2
20 Sensor 2 (4) TxD- 1
8 Sensor 2 (4) RxD+ 4
21 Sensor 2 (4) RxD- 3
24 Sync In+ 6
12 GND 15
Fig. 61 Pin assignment RS422 between IF2008/PCIE and ODC2600
5 1
10 6
15 11
Fig. 62 15-pin. HD subminiature connector, view on solder pin side of cable connector
25-pin.
Sub-D
Signal 15-pin.
Sub-D
Braids
1 Error output (Signal) red
14 Error output (GND) blue
2
Upper tolerance limit
(signal)
purple
15
Upper/ lower tolerance
limit (GND)
black and brown
3
Lower tolerance limit
(signal)
white
16
Upper warning limit
(signal)
pink
4
Upper/ lower warning limit
(GND)
gray and gray / pink
17
Lower warning limit
(signal)
red / blue
20
RS422 reception (negat-
ed)
1
7 RS422 reception (positive) 2
8
RS422 transmission
(positive)
4
21
RS422 transmission
(negated)
3
24 Sync signal input (+) 6
12 Sync signal input (-) 15
25 Analog output (AGND) black (inner conductor)
13 Analog output (signal) green
black (outer shield on 25-pin housing)
Fig. 63 Pin assignment SCD2500-x/IF2008 (15-pin)