MICRO-EPSILON optoCONTROL 2600 User Manual

Page 5
i
optoCONTROL 2600
1. Safety
System operation assumes knowledge of the operating instructions.
1.1 Symbols Used
The following symbols are used in these operating instructions:
CAUTION
Indicates a hazardous situation which, if not avoided, could result
in death or serious injury.
NOTICE
Indicates a hazardous situation which, if not avoided, may result in
minor or moderate injury.
Indicates a user action.
i
Indicates a tip for users.
Measure
Indicates hardware or a button/menu.
1.2 Warnings
Connect the power supply and the display / output device according to the safety regula-
tions for electrical equipment.
> Risk of injury
> Damage to or destruction of the light source/receiver or the controller
Avoid shocks and impacts to the light source/receiver and the controller.
> Damage to or destruction of the light source/receiver or the controller
Protect the cables against damage.
> Failure of the measuring device
The supply voltage must not exceed the specified limits.
> Damage to or destruction of the light source/receiver or the controller
Avoid damage (scratches) to the protective windows of the light source and receiver
through unsuitable cleaning-methods or cleaning solvents.
> Inaccurate, erroneous measuring values
Do not touch the protective windows of light source and receiver with the fingers. Wipe
off any fingerprints immediately.
> Inaccurate, erroneous measuring values
Avoid constant exposure of the measuring channel to dust or splashes of water. Blow off
or use protective housing.
> Damage to or destruction of the light source/receiver or the controller
Avoid exposure of light source/receiver or controller to aggressive media (detergents,
cooling emulsions).
> Damage to or destruction of the light source/receiver or the controller
1.3 Notes on CE Marking
The following apply to the optoCONTROL 2600:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and
the relevant applicable harmonized European standards (EN). The measuring system is
designed for use in industrial environments.
The EU Declaration of Conformity and the technical documentation are available to the
responsible authorities according to the EU Directives.
CAUTION
NOTICE

MICRO-EPSILON optoCONTROL 2600 Specifications

General

Brand	MICRO-EPSILON
Model	optoCONTROL 2600
Category	Measuring Instruments
Language	English