Microgate OPTOJUMP Next - 5 Operating Principles and Data Definitions; 5.1 Definition of Result Columns; 5.1.1 General Information

Version 1.10 Page 133 of 203
5 OPERATING PRINCIPLES
5.1 DEFINITION OF RESULT COLUMNS
5.1.1 GENERAL INFORMATION
 Column #: contains information on the various row types. The following values are
possible
o External: row with a time generated by an external or end of test signal with a
timeout or end of time
o 1,2,….no. (progressive number): valid row. Each row represents a jump and can
contain a contact + flight/step time or only flight/step time
o Averages: average values for the various columns. The average is not calculated for
all columns; it is calculated using only the times of valid rows (indicated with a
progressive number)
o Std: standard deviation of the column compared to the average; the standard
deviation is not calculated for all columns
o Interrupted: if a test is interrupted prematurely by the user, the test finishes with
this warning message
o Error: in a reaction test, if single repetition fails this is signaled with Error
o Deleted: row with contact and/or flight/step times deleted from displays and
calculation of average and total values (see Management of invalid times for more
details)
o Tc not valid: row with invalid contact time; contact + flight/step times for this row
are therefore added to the flight/step time of the row above (see Management of
invalid times for more details)
o Tf not valid: row with invalid flight time; contact and/or flight/step times for this
row are therefore added to the contact time of the line below (see Management of
invalid times for more details)
o No step: in a running/gait test, when the number of steps acquired is lower than
the number of rows with contact + flight times, excessive rows are signaled like this
o Suspended: indicates that a treadmill type test was suspended for a certain time
and then resumed;
o Split: time passed from the Start to the reception of an external split signal, valid
only for running/gait tests;