Version 1.10 Page 51 of 203
4.2.1.1 EXECUTE CONFIGURATION
Figure 35 – Execute Configuration
Test data viewing can be configured by the user. The parameters are:
Execution
o Rotation based on: if more than one test or athlete is selected, this indicates the
chosen mode
Test: after each performance, the next test begins for the same athlete
Athlete: after each test performance this goes on to the next athlete doing
the same test
o Automatic acquisition: if this parameter is set to Yes, it is possible to skip the
manual saving phase at the end of each test; when the athlete finishes a test, it is
saved, then, after a few seconds (as configured in the parameter ‘Acquisition
Pause’) the next test begins automatically (performed by the same athlete or by
another, depending on the settings).
o Acquisition Pause: indicates the pause time between one test and another, which
are acquired automatically. Used only if Automatic Acquisition = YES
o Output 2
nd
Monitor and Save test data: see chap. 4.2.1.2
To Next Page
Loading...
