Microgate OPTOJUMP Next - Page 80

Version 1.10 Page 80 of 203
 Charts displaying the results: it is possible to choose the chart type (lines or bars) and the
measurement to be displayed (times, heights, powers, etc.)
 Table with numerical data: a grid with various lines and columns displays actually acquired
data and calculated data; at the bottom of the table statistical and aggregated data are
displayed (average, minimum, maximum, etc.)
 OptoJump bars: displays the n-number of bars connected at the time the test is carried out
and which LEDs turn on during the test
The table shows the list of all the external, flight and contact times acquired during the test. The
data has been processed to obtain further information such as jump heights, energy, developed
power, etc. See chap.5.1.
In the case of Sprint/Gait test, step length, speed, and acceleration are also displayed.
By checking the various rows, invalid flight and/or contact times can be deleted. See chap. 0
In the bottom left area total test data is displayed, such as:
 Effective time [mm:ss.dd]: actual time of the test in the format minutes, seconds and
milliseconds; this is the difference between the actual start of the test, calculated from
the first event (eg. the first take-off from the ground), and the end of the test.
 Total time [mm:ss.dd]: total time of the test in the format minutes, seconds and
hundredths of a second; this is the difference between the start of the test, signaled by
the acoustic signal, and the end of the test. If, for example, 10 seconds pass between
the two start beeps and the end of the test, and the athlete begins to jump 3 seconds
after the first beep, the two values will be Total time = 10 and Effective time = 7.
 Specific energy [J/kg]: specific energy produced during the test calculated with the
following formula:
 Specific power [W/kg]: specific power expressed during the test calculated with the
following formula:
𝑔
2
∙
∑
𝑇
𝑓
∙ (
∑
𝑇
𝑓
+
∑
𝑇
𝑐
)
4 ∙ 𝑛° 𝑗𝑢𝑚𝑝𝑠 ∙
∑
𝑇
𝑐
Where T
f
= Flight Time, T
c
= Contact Time
 Athlete’s weight [kg or lb]: athlete’s weight in kg or pounds
 Total energy [J]: if the athlete’s weight is available, this field contains the total energy
expressed by the athlete during the test (SpecificEnergy * AthleteWeight)
 Total power [W]: if the athlete’s weight is available, this field contains the total power
expressed by the athlete during the test (SpecificPower * AthleteWeight)