Microhard Systems VIP4G - Page 145

© Microhard Systems Inc. 145
4.0 Configuration
Health Monitor ICMP Timeout
This is the amount of time the Health Monitor will wait for a response from
the ICMP Host.
Values (selection)
1, 2, 3, 4, 5, 10 (seconds)
Attempts Before WAN Failover
This is the number of attempts the VIP4G will attempt to reach the IMCP
host before going into failover and switching WAN interfaces.
Values (selection)
1, 3, 5, 10, 15, 20
Attempts Before WAN Recovery
The VIP4G will continue to monitor the failed interface, even after failover
has occurred. This defines the number of successful attempts required
before recovering the failed interface.
Values (selection)
1, 3, 5, 10, 15, 20
Failover Traffic Destination
Select the interface to use once failover has occurred.
Values (selection)
4G, WAN, Disable
Health Monitor ICMP Host
This is the IP Address or domain name of a valid reachable host that can
be used to determine link health.
Values (Address)
8.8.8.8
Health Monitor Interval
This is the frequency at which the VIP4G will send ICMP packets to the
defined host to determine if the interface has failed.
Values (selection)
5,10,20,30,60,120(sec.)
Disable