Microhard Systems VIP4G - SMS Config; System SMS Commands

© Microhard Systems Inc. 74
4.0 Configuration
Image 4-3-6: SMS > SMS Configuration
This option allows a user to enable or disable to use of the following
SMS commands to reboot or trigger events in the VIP4G:
Status
Values (Selection)
Enable / Disable
If enabled, the VIP4G will only accept and execute commands
originating from the phone numbers in the Phone Filter List. Up to 6
numbers can be added.
Set Phone Filter
Values (Selection)
Enable / Disable
MSC#REBOOT Reboot system
MSC#NMS Send NMS UDP Report
MSC#WEB Send web client inquiry
MSC#MIOP1 open I/O ouput1
MSC#MIOP2 open I/O ouput2
MSC#MIOP3 open I/O ouput3
MSC#MIOP4 open I/O ouput4
MSC#MIOC1 close I/O ouput1
MSC#MIOC2 close I/O ouput2
MSC#MIOC3 close I/O ouput3
MSC#MIOC4 close I/O ouput4
4.3.6 Carrier > SMS Config
SMS messages can be used to remotely reboot or trigger events in the VIP4G. SMS alerts can be set up to
get SMS messages based on system events such as Roaming status, RSSI, Ethernet Link Status or IO
Status.
System SMS Command
MSC#EURD0 trigger event report0
MSC#EURD1 trigger event report1
MSC#EURD2 trigger event report2
MSC#EURD3 trigger event report3
MSC#GPSR0 trigger gps report0
MSC#GPSR1 trigger gps report1
MSC#GPSR2 trigger gps report2
MSC#GPSR3 trigger gps report3
SMS Commands are case sensitive.