© Microhard Systems Inc. 87
4.0 Configuration
The MAC filter allows the control of which WIFI devices can, or cannot
connect to the VIP4G. If set to Allow, only the MAC Addresses listed
will be allowed to connect, all others will be blocked. When set to
Deny, only the devices (via MAC) will be blocked.
MAC Filter
Values (selection)
Disabled / Allow / Deny
The encryption types defines the type of security used for the Wireless
Interface, to join a network a device must know the correct password/
passphrase/key.
Security options are dependent on the version type. This section
describes all available options. Export versions may not have all
optional available to meet regulatory requirements set government
policies.
Encryption Type
Values (selection)
Disabled
WPA (PSK)
WPA2 (PSK)
WPA+WPA2 (PSK)
WPA Enterprise (RADIUS)
WPA2 Enterprise (RADIUS)
WPA+WPA2 Enterprise(RADIUS)
Check this box to show the currently configured password for WPA/
WPA2 encryption passphrase.
Show Password
Values (selection)
unchecked
This is the password, or preshared key that is required by any device
to connect to the wireless interface of the VIP4G. It is strongly
recommended to always have a password defined, and changed from
the factory default.
WPA PSK
Values (string)
0123456789
If using Enterprise (RADIUS) encryption, enter the IP Address of the
RADIUS authentication server here.
RADIUS IP Address
Values (IP Address)
(no default)
If using Enterprise (RADIUS) encryption, enter the port number of the
RADIUS authentication server here.
RADIUS Port
Values (port)
(no default)
This is the password, or preshared key that is required by any device
to connect to the wireless interface of the VIP4G. It is strongly
recommended to always have a password defined, and changed from
the factory default.
RADIUS Server Key
Values (selection)
0123456789
To Next Page
Loading...
