Microhard Systems VIP4G - Page 48

© Microhard Systems Inc. 48
4.0 Configuration
If the VIP4G is integrated into a network which has a defined gateway,
then, as with other hosts on the network, this gateway’s IP address will
be entered into this field. If there is a DHCP server on the network,
and the Connection Type (see previous page) is selected to be DHCP,
the DHCP server will populate this field with the appropriate gateway
address.
Default Gateway
Values (IP Address)
(no default)
DNS (Domain Name Service) Servers are used to resolve domain
names into IP addresses. If the DNS server mode is set for Auto the
DHCP server will populate this field and the value set can be viewed
on the Network > Status page.
Primary/Secondary DNS Servers
Values (IP Address)
(no default)
The WAN can be added as the default route for all traffic exiting the
modem (unless specified otherwise in the Routes menu).
Default Route
Values (selection)
Yes / No
Select between Auto and Manual for the WAN DNS Services. If set to
auto it will be population by the ISP, if set the manual up to (2) DNS
servers can be specified.
DNS server mode
Values (selection)
Auto / Manual