MicroStep-MIS MSB780X1D - Send Read the Output Message in POLL Mode; Unit Change the Measurement Unit

MSB780(X) - User’s Guide
Example:
close<cr>
Command mode is closed
6.25 “send” Read the output message in POLL mode
Use the send a<cr> command to reading output message once in POLL mode, where a is
address of the barometer (0 . . . 255).
Example:
send 200<cr>
! 995.17<cr><lf>
6.26 “unit” Change the measurement unit
MSB780 and MSB780X internally work with hPa unit. Using this command, it is possible to
change output data unit for each pressure quantity separately. The change applies immediately
for all outputs (p, d, send commands, LCD screen, etc.), apart from SDI command R0 which
always returns result in basic units (hPa).
Available units for pressures are: hPa, inHg, psi, torr, bar, mbar, mmHg, kPa, Pa, mmH2O,
inH2O.
Example:
unit<cr>
UNIT:<cr><lf>
P: hPa<cr><lf>
P1: hPa<cr><lf>
P2: hPa<cr><lf>
P3: hPa<cr><lf>
HCP: hPa<cr><lf>
QFE: hPa<cr><lf>
QNH: hPa<cr><lf>
DP12: hPa<cr><lf>
DP13: hPa<cr><lf>
DP23: hPa<cr><lf>
Select quantity:<cr><lf> DP12<cr> Actual unit for DP12 is hPa<cr><lf>
Available units [ hPa, inHg, psi, torr, bar, mbar, mmHg, kPa, Pa, mmH2O, inH2O ]
: mmH2O<cr>
wait..OK
45