MSB780(X) - User’s Guide
6.40 “adjdef” Set default adjustment
This command resets all adjustment coefficients k, q to their default values. For model MSB780X
with more pressure transducers, this command resets coefficients for all of them. This command
also resets adjustment coefficients of analog output.
Note: It is recommended to write down the previous setting of the coefficients, for the case you
would like to return to the previous state.
Actual k, q values can be read using command cnf?, as described on page 34.
Example:
adjdef<cr>
Set default config? (yes/no):yes<cr>
Default adjust config - OK<cr><lf>
wait..OK<cr><lf>
6.41 Corrected pressure commands - QFE, QNH, HCP
The following sections refer to setting parameters for corrected pressures QFE, QNH, HCP and
its calculation method.
6.42 “icaomode” Set mode for calculation of corrected pressures
This command is used for selection of formula for calculation QFE and QNH corrected pres-
sures. For calculation formulas see hqfe command on page 52 and hqnh command on page
53.
Example:
hqnh<cr>
Actual setting: yes<cr><lf>
Use ICAO mode? [yes/no]: yes<cr>
wait..OK<cr><lf>
If you do not want to change actual setting, enter empty input - only <cr>(<lf>).
6.43 “icaodigits” Set number of decimal praces of corrected pressures
In ICAO mode it is possible to set truncating of QFE and QNH corrected pressures.
51
To Next Page
Loading...