MicroStep-MIS MSB780X1D - History of Changes; 1.1; 1.2; 1.2.1

MSB780(X) - User’s Guide
14 History of changes
14.1 V 1.1
• Fixed resolution to three decimal places in [hPa] units.
• Corrected string “0000” to “000” in chapter “Start Measurement Command (aM!).
• Updated “Principle of operation” chapter, added NOTE on calibration.
14.2 V 1.2
• Added Resolution to table “Parameters of sensor”.
• Changed Serial interface UART 3.3 V to RS-232.
• Increased level of “Table of contents” to 2
• Removed “analog output” from “Introduction” chapter.
• Added “RS-485 serial interface” to “introduction” chapter.
• Added “5 terminal version” picture
14.3 V 1.2.1
• Added “seri” command
• Added “cset” command
14.4 V 1.2.2
• Added following commands: hqfe, hqnh, tqfe, hqfe?, hqnh?, tqfe?, unit, unit?
14.5 V 1.2.3
• Added Section: Maintenance.
14.6 V 1.2.4
• Added Section: Calibration and Adjustment.
98