Milestone UltraGROSS - Page 149

UltraGROSS
MM182-001 – Operator Manual
149
- Connect the 2 m long control cable to UltraGROSS (left image below, rear right or left side) and to
VIROCLEAN.
- Connect the supplied power cable to a socket outside of the unit and switch on the unit with the relative
ON/OFF button.
- See chapter 2.6.5 for starting the program.
- In case of errors, the appliance will trigger an alarm on its terminal.
Only use the reagent shown in the next chapter.
Do not stand within 2 meters around the instrument for at least 30 minutes from the end of
the decontamination cycle.