4-22
Check if the registered nozzle is recovered
You can check whether registered nozzle has been successfully recovered.
With the following settings “ON”, you can print a test pattern using a recovered nozzle when test print ( P.2-
13).
1
Select [NOZZLE RECOVERY] of the maintenance
menu.
(1) Press the key in LOCAL.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the key.
2
Press to select [CONFIRM MENU] and
press the key.
3
Press to select “ON” and press the
key.
4
Press the key several times to end the setting.
• When test print with the recovered nozzle that was registered in the nozzle recovery, please select
“ON” in step 3 of P.2-13 “Test Printing”.
To Next Page
Loading...
