1-12
Replace the ink bottle
Perform as follows when [INK END] or [INK NEAR END] is displayed on the display.
When [INK END] is displayed
1
Move the lever on the tank completely from the left
to the right end.
2
Lift out the ink bottle while keeping it completely
straight.
3
Wipe off any ink adhering to the cap.
(1) Wipe off any ink adhering to the undersurface of the cap using
the cap wiper section on the rear of the tank.
(2) Set the bottle with cap upright and use a disposable wipe or
similar item to wipe off any ink adhering to the cap.
• Do not ever rotate the ink bottle at all after
setting it into the tank. Doing so can result in
ink leakage.
• Check that the light-blocking cover closes
when removing the ink bottle from the tank.
Close by hand if the cap does not close.
Leaving the light-blocking cover open can
result in the ink curing.
To Next Page
Loading...
