Setting ink bottles
1-13
1
Before Use
3
4
5
6
4
Remove the cap from the used ink bottle.
• Use the tightening jig to remove the cap if it is difficult to remove.
5
Refer to P.1-9 “Setting ink bottles” to set the new ink bottle.
When [INK NEAR END] is displayed
There is a little of ink left. It is recommended to replace the ink bottle soon since ink may become empty in
printing while printing is continuously enabled.
When you press the key in LOCAL, you can check the bottle to be replaced in the local guidance.
( P.3-30)
If the light-blocking cover comes off
If the light-blocking cover comes off, light striking the inside of the tank can result in the ink curing.
Perform the following procedures if the light-blocking cover comes off.
1
Insert the nub (on one side) of the light-blocking cover
into the hole on the tank.
2
While pressing towards the side of the inserted hole of Step 1, insert the other nub
into the other side.
• Do not leave an ink bottle with the specialized cap attached in a location where it is
exposed to light for a long period of time. Doing so can result in the ink in the bottle curing.
To Next Page
Loading...
