2-11
1
2
Basic Operations
4
5
6
Move the irradiation position of the UV lamp
Three layers print that overlap the white ink layer on the
primer layer and then overlap the color ink layer
• The left and right of the UV lamp at 0mm position at
primer printing
Move to 65mm position at the white and color printing
Three layers printing that overlap the color ink layer on
the primer layer and then overlap the clear ink layer
• The left and right UV lamp at 65mm position at primer +
color printing
Move to 0mm position at clear printing
Three layers print that overlap the white ink layer on the
primer layer and then overlap the clear ink layer
• Move the left and right UV lamp to 0mm position.
(Do not change the location at the middle of the print)
Four layers print that overlap the white ink layer on the
primer layer, and then overlap the color ink layer and the
clear ink layer (same for the case of thickness print of
clear layer)
• The left and right UV lamp at 0mm position at the primer
printing
65mm position at the white and color printing
Move to 0mm position at clear printing
*1. The lamp position should be above setting when you priotize the image quarity, and the lamp position need to be changed. (The
machine suspend before printing clear ink and the alarm will be shown on RasterLink.)
If you can not change the lamp position during the print, please set the lamp position at 0mm BEFORE printing.
(3) Adjustment on LUS-120
4-colors (M/M/K/K/C/C/Y/Y)
Printing method UV lamp position
Single-layer printing: printing color ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
4-colors + white ink (M/K/C/Y/M/C/W/W)
Printing method UV lamp position
Single-layer print that prints color ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
Two layer print that overlap the white ink layer on the color ink
layer.
• Move the right and left UV lamp to the position at 0mm.
Two layer print that overlap the color ink layer on the white ink
layer.
• Move the right and left UV lamp to the position at 190mm.
4-colors + clear ink + white ink (M/K/C/Y/CL/CL/W/W)
Printing method UV lamp position
Single-layer print that prints color ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
Single-layer print that prints clear ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
Three layers print that overlap the color ink layer on the white
ink layer and then, overlap the clear ink layer.
• Move the right and left UV lamp to the position at 65mm
*1
when
printing with white + color and it move to the position at 0mm
when printing with clear ink.
*1. The lamp position should be above setting when you priotize the image quarity, and the lamp position need to be changed. (The
machine suspend before printing clear ink and the alarm will be shown on RasterLink.)
If you can not change the lamp position during the print, please set the lamp position at 0mm BEFORE printing.
Thickness print that overlap the multilayer of clear ink on color
ink layer.
• Move the right and left UV lamp to the position at 0mm.
Thickness print that overlap the color ink layer on the white ink
layer and then, overlap the multilayer of clear ink.
• Move the right and left UV lamp to the position at 65mm
*1
when printing with white + color and them move to the position at
0mm when printing with clear ink.
To Next Page
Loading...
