MIMAKI JFX550-2513 - Flushing Filter Replacement; NCU Ink Pad Replacement

Chapter 4 Maintenance
125
Flushing Filter Replacement
The machine counts the amount of ink used in flushing. When a specified value is reached, SYSTEM
ALARM will appear on the touch panel. Use this as a guide for replacing the flushing filter.
1
From MENU on the touch panel, tap [MAINTENANCE].
• The Maintenance menu is displayed.
2
Tap [Replace parts] > [Replace flushing filter].
• The carriage moves over the table.
3
Remove the flushing filter.
Flushing filter
4
Clean around the flushing filter.
• "Station Area Cleaning"(P. 116)
5
Install a new flushing filter.
6
Tap [Complete] > [Finish] once replacement is complete.
• This resets the ink flushing amount.
NCU Ink Pad Replacement
If the NCU ink pad must be replaced, "0657 Check NCU waste ink" will appear in SYSTEM ALARM on the
touch panel. Use this as a guide for replacement.
1
From MENU on the touch panel, tap [MAINTENANCE].
• The Maintenance menu is displayed.
2
Tap [Replace parts] > [Replace NCU absorbent].
• The carriage moves over the table, and the station rises.
4