MIMAKI JFX550-2513 - 5.2 Problems Indicated by Messages

Chapter 5 Troubleshooting
139
5.2 Problems Indicated by Messages
If a problem occurs, the buzzer will sound and a message will appear in SYSTEM ALARM on the touch
panel. Take appropriate measures based on the message. If a message is displayed again even after you
take the recommended corrective action, contact your local dealer or our service office.
Error
numbe
r
Message Cause Corrective action
0104 +35V RECVR • A control PCB problem
was detected.
• Turn off the control PC, then turn off
the main power. Wait briefly before
turning the control PC and the main
power back on.
010E FROM CLEAR
010F FROM WRITE
0115 PCB MAIN-F1
0116 PCB MAIN-F2
011F PCB SLIDER
0122 CHECK :SDRAM
0123 PRAM DATA
0124 PRAM ADDR
0127 POWER OFF
0128 HDC FIFO
0129 BATTERY EXCHANGE • The machine has detected
that the internal clock
battery is nearly
exhausted.
• Contact your local dealer or our
service office.
012A HDC SPEED • A problem was detected
with the print head control.
012D PCB MAIN-F4 • Blown main PCB fuse. • Turn off the control PC, then turn off
the main power. Wait briefly before
turning the control PC and the main
power back on.
012E HeadFaild • A problem was detected
with the head.
0151 Main PCB V1R2 • A problem was detected
with the main PCB power
supply circuit.
0152 Main PCB V2R5
0153 Main PCB V3R3
0154 Main PCB V05
0155 Main PCB V36-1
0156 Main PCB V5B
0157 Main PCB VTT
0158 Main PCB V36-2
016E Main PCB V3R3B
0171 NEW HEAD CONNECT • New head connection
detected.
0172 Main PCB Q6 Check • A problem was detected
with the main PCB power
supply circuit.
0181 PCB H21 • The HDC PCB 1 could not
be detected.
5