MIMAKI JFX550-2513 - 1.1 Part Names and Functions

Chapter 1 Before Use
34
1.1 Part Names and Functions
1
3
4
19
5
7
8
12
13
15
6
6
18
10
11
14
6
7
16
9
17
2 20
No. Name Overview
1 Y-bar The Y-bar is equipped with a carriage. This part moves over the table to
print.
2 Table Print area. Features a large number of holes used to secure the media
under vacuum pressure. "Load the media."(P. 60)
3 Cable carrier (Y-bar) Ink tubes and other parts are routed through the cable carrier. Do not insert
your hands or other objects into the cable carrier.
4 Carriage Consists of a print head, a UV-LED lamp, and the jam sensor.
"Carriage"(P. 36)
5 Signal tower light To confirm machine status, check the color of the illuminated lights. A
buzzer sounds to signal that the carriage and Y-bar will begin moving soon.
"Signal tower light"(P. 37)
6 Emergency stop switch Press to stop the machine in emergencies. Two emergency stop switches
are positioned at the left and right ends of the Y-bar. An additional switch on
an extension can be kept in a separate room or in an area behind a safety
partition.
• When you stop the machine by pressing the emergency stop switch,
follow the steps below to unlock the switch.
1. Resolve the problem.
2. Rotate the emergency stop switch to unlock it.
3. Clear the alarm on the touch panel. "Clearing Alarms"(P. 99)
– Clearing the alarm will start the initial operations.
7 Light curtain Detection of a person or object will halt the machine. "Light
curtain"(P. 38)
8 Capping station Includes caps, wipers, and an NCU for monitoring print head nozzle
conditions. "Capping station"(P. 36)
9 Waste ink tank Container for waste ink. "Waste Ink Tank Replacement"(P. 127)