This is used to check if the nozzles are clogged before printing. Set whether to perform maintenance
functions automatically if nozzle clogging is detected.
If ≥ the set value
[Nozzle check before print]
On
The nozzles are not checked.
Off
Perform nozzle recovery.
Nozzle check (nozzle clogging detection)
Continue Printing
If less than the set value
[Judgment condition] setting value for nozzle clogging
detection
[Nozzle Recovery] (cleaning followed by nozzle
checking) (Repeated by [Retry count] cycles)
[Judgment condition] setting value for nozzle clogging
detection
Stop Printing.
If ≥ the set value
[Nozzle recovery]
On
Off
If less than the set value
To Next Page
Loading...
