Chapter 2 Printing
58
2.1 Print Process
1.
Setting Up RIP Software
"Installing the Mimaki Driver"(P. 45) (required first time only)
"Installing RIP Software"(P. 46) (required first time only)
"Obtaining Color Profiles"(P. 46)
"Setting up an Ethernet connection"(P. 42) (required first time only)
2.
Set up the control PC and RIP PC on the same local network.
"Connecting to a Local Network"(P. 40) (required first time only)
– If the system is not connected to a local network, you can use a removable disk to store jobs (RIP
data) in MPC. "With output port set to [File]"(P. 80)
3.
Load the media.
"Load the media."(P. 60)
Suction area 2
Suction area 1
Origin
X: 775 mm
1300 mm
Y: 2500 mm
[Print Area]
[Table]
Rear side
Front side
4.
Register the media thickness.
"Registering the Media Thickness"(P. 66)
5.
Set the head gap.
"Setting the Head Gap"(P. 69)
6.
Check the state of the print head nozzles.
To Next Page
Loading...
