MIMAKI JFX550-2513 - Bottle Ink Wipe Filter Replacement

Chapter 4 Maintenance
126
3
Remove the NCU ink-receiving pan.
• Slide forward to remove.
4
Remove the ink pad from the NCU ink-receiving pan.
Ink pad
5
Clean the NCU ink-receiving pan.
6
Install a new NCU ink pad.
7
Install the NCU ink-receiving pan.
• Insert until it clicks into place, and confirm that the tabs are engaged.
8
Tap [Complete] > [Finish] once replacement is complete.
• This resets the NCU ink pad count.
Bottle Ink Wipe Filter Replacement
Check the bottle ink wipe filters and replace if very dirty.
1
Remove the wipe filters.
Wipe filters