MIMAKI JFX550-2513 - A Pressure Error Occurred

Chapter 5 Troubleshooting
135
4
The nozzle surface is cleaned.
• Gently press a cleaning stick moistened with maintenance fluid against the nozzle surface for
about 10 seconds.
Press gently for about 10 seconds.
• Do not rub or press the cleaning stick with excessive force against the nozzle surface.
Doing so may cause print head wear.
• Do not reuse cleaning sticks.
5
Once cleaning is complete, slide the maintenance cover on the left side of the Y-bar to close
it.
Maintenance cover
Lever
• Make sure the maintenance cover is returned to the correct position.
6
Tap [Complete] > [Finish].
7
Execute cleaning (in normal mode).
• "Head Cleaning"(P. 73)
8
Make a test print and check the print results.
• Repeat the cleaning and test printing process until the print results appear normal.
A pressure error occurred.
Depending on the usage environment and machine service life, the pressure controlled by the machine may
exceed the range. If a pressure error occurs, adjust the pressure as soon as possible to restore normal
conditions.
l
For positive pressure adjustment
1
From MENU on the touch panel, tap [MAINTENANCE].
• The Maintenance menu is displayed.
5