Chapter 2 Printing
61
Load the media.
Supported Media Thickness
0.0 mm to 60.0 mm (default value 0.0 mm)
• Be careful to avoid dropping heavy media on the table. Disregarding this precaution may impair
the precision of the table surface and affect print quality.
1
Load the media on the table.
• Use the positioning pin as a guide when loading media. "Using the Positioning Tools"(P. 62)
• Use adhesive tape or similar to hold down curled media edges against the table surface.
• To increase media suction, load unneeded media (thinner than the media for printing)
against the suction on the table where no media is loaded.
• Load media to avoid concentrating weight (up to 50 kg per m
2
) in one location.
2
Open the suction valves needed for the size of the media used.
Open
Close
Valve for
suction area 1
Valve for
suction area 2
• For more information on the suction area, see below.
Suction area 2
Suction area 1
Origin
X: 775 mm
1300 mm
Y: 2500 mm
[Print Area]
[Table]
Rear side
Front side
3
From QUICK MENU on the touch panel, tap [Vacuum] or step on the foot switch to apply
suction to the media.
• Be sure to remove the positioning pin (or commercially available screw) if it protrudes past
the media once the media is in place. The print head may come into contact with the pin/
screw.
2
To Next Page
Loading...
