MIMAKI JFX550-2513 - Printing; Repositioning the UV-LED Unit

Chapter 2 Printing
83
2.9 Printing
Check beforehand
• Is media loaded? "Load the media."(P. 60)
• Did you set the media thickness? "Registering the Media Thickness"(P. 66)
• Did you set the head gap? "Setting the Head Gap"(P. 69)
Repositioning the UV-LED Unit
Loosen the screws on both sides of the carriage and slide the UV-LED unit as needed for the colors and spot
colors you wish to print.
Screw
Screw
Carriage
[Rear]
[Front] [Front]
[Rear]
• Keep foreign matter out of the grooves on either side of the carriage where the UV-LED unit
slides. Screws or pieces of metal that fall into the grooves may result in fire or smoldering.
UV-LED unit position
the machine supports two-layer printing in separate layers for colors and spot colors.
The following position is recommended for the UV-LED unit:
l
4-color, W, CL
Layer Layer Printing UV-LED Unit Position
Single layer Front
Front
Front
Two layers
2nd layer:
1st layer:
Rear
2nd layer:
1st layer:
Front
2nd layer:
1st layer:
Front
l
4-color, W, CL, Pr
Layer Layer Printing UV-LED Unit Position
Single layer Front
Front
Front
Front
2