MIMAKI JFX550-2513 - Printing Using Nozzle Recovery

Chapter 2 Printing
87
Moving the Y-Bar to the View Position
1
From QUICK MENU on the touch panel, tap [View position].
• A dialog box appears.
2
Tap [Move].
• The Y-bar moves to the view position.
Changing the View Position
1
From MENU on the touch panel, tap [SETTING 2].
2
Tap [View position] > [View position].
• A dialog box appears.
3
Enter the view position.
• Tap [-] / [+] to enter the value.
• Use the [Numeric keypad] to enter your specified value.
(1) Tap .
• A dialog box appears.
[Enter]
(2) Enter the preferred value, then tap [Enter].
4
Tap [SET].
Printing Using Nozzle Recovery
Nozzle recovery is a function that is useful when nozzle clogging cannot be resolved for specific nozzles.
When nozzle recovery is enabled in Mimaki Printer Controller (MPC), if a nozzle is determined to be "nozzle
clogging" in the nozzle check, normal nozzles are used supplementarily during printing.
2