Chapter 4 Maintenance
130
• During touch panel operation, the Y-bar will move to the front of the table. Do not
approach the machine until the Y-bar has come to a complete stop.
5
Remove the caps for water supply and air purging.
For water supply
For air purging
6
Inject the mixture of water and antifreeze.
• The buzzer will stop after you inject about 400 ml of the mixture into each tank.
7
After the buzzer stops, inject an additional 430 ml of the mixture into each tank.
• Do not inject more than 430 ml of additional mixture. Injecting more may cause the tank to
overflow.
8
After injection is finished, replace the caps.
To Next Page
Loading...
