Connecting the Power
19
2
Have a licensed electrician assemble the plugs and cables as shown below.
N
G
L
Cable core securing section
Cable core retaining screws
Cable core cover
Cable retainer nut
(1) Assemble the ends of the cables as shown in the figure.
30 mm
10 mm
13 mm
25 mm
Black 1: L
Black 2: N
Green/
Yellow: G
(2) Loosen the cable retainer nut by turning it counterclockwise.
• The cable retainer nut should not completely come off. If it happens to come off, reinstall it
so that its protrusion mates with the protrusion of the core wire cover.
Core wire cover
Cable retainer nut
Cable retainer
Core wire cover
Cable retainer
Cable
A-A cross-section
(3) Remove the core wire cover by turning it counterclockwise while pressing down on the black
protrusion with a flathead screwdriver.
(4) Thread the cable through as shown in the diagram of the plug and cable.
• Be sure to pay particular attention to the direction of the wiring.
(5) Secure the wires in place using the core wire screws while ensuring correct polarity.
(6) Install the core wire cover. This will fit in place after turning it clockwise. After installation,
confirm that it does not come off by pulling it gently.
• Turn it clockwise to find the position where it fits. Pull it gently to confirm that it does not
come off.
(7) Turn the cable retainer nut clockwise to confirm it is securely holding the cable in place.
To Next Page
Loading...
