WARNING: Never insert the reservoir into the pump while the
tubing is connected to your body. Doing so could result in an
accidental infusion of insulin, which may cause low BG.
You must rewind your pump before installing a new reservoir to
ensure correct insulin amount.
To insert the reservoir into your pump:
1. If you are using the pump for the first time, remove the shipping cap from
the reservoir compartment.
2. Rewind your pump if you have not yet done so. See Rewinding your pump, on
page 94 for more information.
3. Insert the reservoir into the top of the reservoir compartment.
4. Turn the tubing connector approximately a half-turn clockwise until the
connector is locked. The tubing connector should be aligned horizontally with
the pump case as shown in the following example.
tubing connector
5. Your pump should be displaying the New Reservoir screen shown in the
following example. Select Next to continue.
100 Chapter 5
MP6025957-024 / A
RELEASED
To Next Page
Loading...
