Caution: When using Audio or Vibrate, it is possible that an Audio or
Vibration notification may not occur as expected if the speaker or
vibrator in your pump malfunctions. This is most important when
using the Easy Bolus feature or when your pump is in Manual Suspend
where a missed notification may cause an over or under delivery of
insulin.
Contact the 24 Hour HelpLine or your local representative with any
concerns.
To use the Easy Bolus feature, you need to put your pump into sleep mode by
pressing and holding the Menu button
for about two seconds.
To deliver a bolus using Easy Bolus:
1. While your pump screen is in sleep mode, press and hold for about one
second. After your pump beeps or vibrates, release . You can now start
programming your Easy Bolus.
Note: If your pump does not respond when you press , it may
not be in sleep mode, even if the screen is dark.
2. Press the number of times needed to set your bolus amount.
Each time you press , your pump sounds a tone or vibrates, and your bolus
amount increases by the number of units set for the step size.
Note: You cannot use to select the Easy Bolus values. Pressing
cancels the Easy Bolus.
3. When you have reached the desired bolus amount, press and hold to
confirm the amount. You should hear a confirmation tone or feel a vibration
for each button press. Count to ensure the amount is correct. If the amount is
not correct, press and hold until you hear a tone, and then start again from
step 1.
■
bolus
Bolus 85
MP6025957-024 / A
RELEASED
To Next Page
Loading...
