9. Commissioning
MiR200 User Guide (en) 10/2020 - v.3.1 ©Copyright 2017-2020: Mobile Industrial Robots A/S. 100
can be on any side of the robot. The marker is shaped liked an L, and the dimensions are 400
mm x 600 mm and must have a defined angle of 90˚.
Figure 9.11. The icon used for L-markers in the interface and an illustration of how robots can dock to the
marker.
A Bar-marker can be used for forward or reverse docking between two bars or plates,
similar to pallet racks or shelves. Bar-markers must be between 400 mm and 750 mm long,
and the distance between the bars must be between 750 mm and 1500 mm.
The distance between the bars must be larger than the footprint of your robot.
Figure 9.12. The icon used for Bar-markers in the interface and an illustration of how robots can dock to the
marker.
A few centimeters between all the types of markers should make docking possible.
Determine during commissioning if more space is required.
To Next Page
Loading...
