SECTION
MITL9105/911
O-096-350-NA
TABLE 4-12 (CONT’D)
EXTENDED PROGRAMMING ERROR CODES
-
SUPERSET
PROGRAMMING
Error
Key
Code
involved
E22 PRIME KEY
Explanation
This occurs when attempting to add a prime, but the
directory number supplied exists, and does not exist as a
primeless list.
This error is also given if the directory number supplied
(when adding a prime) does not exist, but conflicts with an
existing system access code.
E23 REVIEW This is given in Review mode, when the directory number
supplied does not exist, or is in conflict with an existing
system access code.
E24 REVIEW
This is given in Review mode, when the directory number
supplied exists, but not as either a prime line access code -or
the access code for a primeless appearance list. This error
indicates in the first three digits of the SOURCE display who
the actual owner is.
If the first digit is 0:
-000
-
135 equipment numbers 1 to 136
-136
-
147 trunk group numbers 1 to 12
-148
-
159 hunt group numbers 1 to 12
-160
-
255 equipment numbers 161 to
256..
If the first digit is a 1:
000
-
063 service routines 1 to 64 (features).
E25
LISTED NUMBER
An attempt has been made to change the DN of a Prime key,
but the new directory number (listed number) is in use or is
in conflict with an existing access code. The new listed
number for a Prime key must be unique, and cannot be that
of a primeless list even.
E26
TRUNK EQPT
NUMBER
The equipment number entered (after pressing TRUNK EQPT
NUMBER) is not that of a defined CO trunk or Dial-In trunk
The equipment number entered here must have been defined
in Standard Programming as a trunk Also, if in Review mode,
this error means that the equipment number entered (after
pressing TRUNK EQPT NUMBER) has not been used for either
a DTS or private line key.
E27 The trunk is currently assigned to a DTS appearance list. An
attempt has been made to use it for a private line key.
E28
An attempt has been made to assign a port for call announce
use but the port is currently programmed for another
function. The Call Announce Port must be dedicated to the
call announce function.
Page 48
To Next Page
Loading...
