SECTION
MlTL91
OS/91
1
O-096-350-NA
i
f&i
.
.
-:
‘-
;::
(.
-.
TABLE 4-12 (CONT’D)
EXTENDED
PROGRAMMlNG
ERROR CODES
-
SUPERSET
PROGRAMMING
Error
Key
Code
involved Explanation
E28
ANNOUNCE EQPT
NUMBER
Attempting to assign an equipment number as a Call
Announce Port when other equipment numbers previously
programmed for that slot identify the slot as other than a
Line card.
E30
An attempt has been made to delete a Prime key (this is
equivalent to deleting the set) and a Non-Prime key on the
set was defined. Before a set can be deleted, all Non-Prime
keys must be undefined (deleted).
E31
An attempt has been made to define a Non-Prime key when
the prime for the equipment number has not yet been
defined (the set itself has not been defined). The Prime key
must be the first key defined for a set.
E32 NEW SET EQPT
NUMBER
When attempting to move a set the equipment number
specified cannot be moved as it is not programmed as a
SUPERSET
set.
E33
E33
NEW SET EQPT
NUMBER
NEW SET EQPT
When attempting to move a set to a new equipment number
that has been programmed already.
Attempting to move a
SUPERSET
set to an equipment
number when other equipment numbers previously
programmed for that slot identify the slot as other than a
SUPERSET
Line card.
E40
A Prime key is being added, and the listed number is the
same as an existing primeless list. This can normally be
done, but in this case, the primeless list is not idle, so the
addition of the prime cannot be performed.
E41
Addition of a key line appearance is attempted, but cannot be
performed because the listed number is not idle. Or, addition
of a DTS or private line was attempted, but cannot be
performed because the trunk chosen for the key is not idle.
E42
An attempt has been made to delete a Prime key, but the
listed number is not completely idle. Note: All multiple call
appearances of a prime must be idle if the prime is to be
deleted; i.e., when a multiple call appearance ‘somewhere’ is
busy it will prevent prime deletion although the prime
appears idle. When this happens, use the Review mode to
find where all the appearances are, then delete each
individually. The busy one will cause an error.
Page 49
To Next Page
Loading...
