Mitsubishi Electric Q173DSCPU - Page 121

3 - 10
3 MOTION DEDICATED PLC INSTRUCTION
[Start accept flag (System area)]
The complete status of start accept flag is stored in the address of start accept flag in
the CPU shared memory for target CPU.
CPU shared memory address
( ) is decimal address
Description
204H(516)
205H(517)
The start accept flag for 32 axes are stored corresponding to each bit.
Bits are actually set as the following:
• Q173DSCPU/Q173DCPU(-S1) : J1 to J32
• Q172DSCPU : J1 to J16
• Q172DCPU(-S1) : J1 to J8
OFF : Start accept enable
ON : Start accept disable
b1b15
J16
J32
205H(517) address
204H(516) address
J2 J1
J18 J17
b0b14 b2
20EH(526)
20FH(527)
QDS
The command generation axis start accept flag for 32 axes are stored
corresponding to each bit.
Bits are actually set as the following:
• Q173DSCPU: J1 to J32
• Q172DSCPU: J1 to J16
OFF : Start accept enable
ON : Start accept disable
b1b15
J16
J32
20FH(527) address
20EH(526) address
J2 J1
J18 J17
b0b14 b2