Mitsubishi Electric Q173DSCPU - Page 483

12 - 16
12 ERROR CODE LISTS
Error
code
Details
code
Error factor
Error Processing Corrective Action
Name Description
16417
1
Cam auto-generation
(CAMMK) execution
error
Cam No. specified by (S1) is outside the
range of 1 to 256.
The block processing
on executing is
stopped and the next
block is executed.
Correct the program so that the cam No. is
within the range of 1 to 256.
2
Auto-generation type specified by (S2) has
been set to a value that does not
correspond to an auto-generation type.
Correct the program to specify a value that
corresponds to an auto-generation type.
3
• There is not enough free area in cam
storage area.
• It is impossible to write according to the
free area.
• Decrease the cam data number (cam
number, cam resolution, coordinate
number).
• Delete the cam data and write again.
4
• There is not enough free area in cam open
area when write to cam data.
• It is impossible to write according to the
free area.
Decrease the cam data number (cam
number, cam resolution, coordinate number).
5
The end device number for auto-generation
data which the first number of storage auto-
generation data is specified by (S3) is
outside the range.
Correct the program so that the end device
number for auto-generation data is within the
setting range.
6
The first number of the storage device for
(S3) auto-generation data is not even-
numbered.
Correct the program so that the device
number is an even-numbered.
7
Some data outside the range has been set
in auto-generation data.
Correct the setting value of auto-generation
data within the setting range.
8
For the cam rotary cutter, a value has been
set as sheet synchronization width  sheet
length in the auto-generation parameter.
Review the value of auto-generation
parameter so sheet synchronization width <
sheet length.
9
For the cam rotary cutter, asynchronous
speed will be reduced when the auto-
generate data is set as synchronous axis
length (synchronous axis diameter × ) <
sheet length.
Review the setting value for auto-generation
data so that the asynchronous speed cannot
be reduced.
10
For the cam rotary cutter, asynchronous
speed is 655.35 times or larger than
synchronous speed by auto-generation
data.
Review the setting value of auto-generation
data so that the asynchronous speed is not
higher than 655.35 times the synchronous
speed.
11
Execute cam auto-generation when "Write
protection" or "Read/write protection" of cam
data is set with password.
Execute the auto-generation operation after
the password is disabled.
12
Execute CAMMK instruction when writing
cam data (CAMWR instruction, CAMWR2
instruction or CAMMK instruction) by Motion
SFC program.
Correct the program to set the CAMMK
instruction not execute when the cam data
write flag (SM505) is ON.
20
For the easy stroke ratio cam, the end
points for each section are not in ascending
order.
Set a value for each end point that is larger
than the previous end point.
21
For the easy stroke ratio cam, the end point
of the final section is less than the cam axis
length per cycle.
Set the end point of the final section as the
cam axis length per cycle.