9 COMMON FUNCTIONS
9.2 Parameter Initialization Function
305
9
Parameter initialization method
• Parameter initialization can be carried out by writing the data shown in the table below to the buffer memory of Simple
Motion module. The initialization of the parameter is executed at the time point the data is written to the buffer memory of
Simple Motion module.
Refer to the following for the setting details.
Page 504 Control Data
When the initialization is complete, "0" will be set in "[Cd.2] Parameter initialization request" by the Simple Motion module
automatically.
Setting item Setting
value
Setting details Buffer memory address
[Cd.2] Parameter initialization request 1 Set "1" (parameter initialization request). 5901
To Next Page
Loading...
