8 CONTROL SUB FUNCTIONS
8.2 Sub Functions Specifically for Machine Home Position Return
221
8
Home position shift function
When a machine home position return is carried out, the home position is normally established using the near-point dog and
zero signal. However, by using the home position shift function, the machine can be moved a designated movement amount
from the position where the zero signal was detected. A mechanically established home position can then be interpreted at
that point.
Control details
The following drawing shows the operation of the home position shift function.
Setting range for the home position shift amount
Set the home position shift amount within the range from the detected zero signal to the upper/lower limit switches.
[Pr.44] Home position return direction
Zero signal
Near-point dog
[Pr.47] Creep speed
[Pr.53] Home position shift amount
Speed selected by the "[Pr.56] Speed
designation during home position shift"
Machine home
position return start
[Pr.46] Home position
return speed
Setting range of the positive home position shift amount
Lower limit switch
[Pr.44] Home position return direction
Near-point dog
Upper limit switch
Zero signal
Setting range of
the negative
home position
shift amount
Address
decrease
direction
Address
increase
direction
To Next Page
Loading...
