624
APPENDICES APPENDIX
Appendix 3 Compatible Devices with SSCNETIII(/H)
Appendix 3 Compatible Devices with SSCNETIII(/H)
Servo driver VCII series manufactured by Nikki Denso Co., Ltd.
The direct drive DISC/iD roll/Servo compass/Linear stages, etc. manufactured by Nikki Denso Co., Ltd. can be controlled
by connecting with the servo driver VC series manufactured by the company using SSCNET or SSCNET/H.
Contact to Nikki Denso overseas sales office for details of VC series.
Connecting method
■System configuration
The system configuration using VC series is shown below.
■Parameter setting
To connect VC series, set the following parameters.
n: Axis No.-1
*1 For SSCNET connection
*2 For SSCNET/H connection
Parameters set in VC series are not controlled by the Simple Motion module.
Setting item Setting value Default value Buffer memory address
[Pr.100] Connected
device
00080102H: VC (Manufactured by Nikki Denso Co., Ltd.) (For linear stage)
*1
00080107H: VC (Manufactured by Nikki Denso Co., Ltd.) (For direct drive motor)
*1
00081000H: VC (Manufactured by Nikki Denso Co., Ltd.)
*2
0 58020+32n
58021+32n
SSCNET
µ
(/H)
RD77MS2: Up to 2 axes
RD77MS4: Up to 4 axes
RD77MS8: Up to 8 axes
RD77MS16: Up to 16 axes
Servo amplifier *
MR-J3(W)-_B/MR-J4(W)-_B
SSCNET
µ
cable
MR-J3BUS_M(-A/-B)
Servo driver
VC´ series
Simple Motion module
RD77MS4
ERRRUN
AX
3
4
2
1
AX
* MR-JE-_B can be connected via SSCNET
µ
/H.
To Next Page
Loading...
