Mitsubishi Electric RD77MS2 - Target Position Change Function

8 CONTROL SUB FUNCTIONS
8.5 Functions to Change the Control Details
263
8
Target position change function
The "target position change function" is a function to change a target position to a newly designated target position at any
timing during the position control (1-axis linear control). A command speed can also be changed simultaneously.
The target position and command speed changed are set directly in the buffer memory, and the target position change is
executed by "[Cd.29] Target position change request flag".
Details of control
The following charts show the details of control of the target position change function.
■When the address after change is positioned away from the start point more than the
positioning address:
■When the speed is changed simultaneously with changing the address:
■When the direction of the operation is changed:
Positioning address Address after change
t
V
Target position change request
Positioning address
Address after change
Target position change request
t
V
Speed before
change
Speed after change
Positioning address
t
V
Address
after
change
Target position change request