12 DATA USED FOR POSITIONING CONTROL
12.1 Types of Data
365
12
: Always set
: Set as required ("" when not required)
: Setting not possible
: Setting restricted
: Setting not required (The setting value is invalid. When the value is the default value or within the setting range, there is no
problem.)
Common parameter Manual control Expansion
control
Related sub
function
Manual pulse
generator
operation
Inching
operation
JOG operation Speed-torque
control
[Pr.24] Manual pulse generator/Incremental
synchronous encoder input selection
[Pr.82] Forced stop valid/invalid selection Page 246
Forced stop
function
[Pr.89] Manual pulse generator/Incremental
synchronous encoder input type
selection
[Pr.96] Operation cycle setting
[Pr.97] SSCNET setting
[Pr.150] Input terminal logic selection
[Pr.151] Manual pulse generator/Incremental
synchronous encoder input logic
selection
[Pr.152] Maximum number of control axes
[Pr.153] External input signal digital filter
setting
To Next Page
Loading...
