Mitsubishi L Series User Manual

96
(b) Operation of when Operating condition setting request (Y9) is turned OFF → ON →
OFF during difference conversion
During the difference conversion, even if Operating condition setting request (Y9) is turned OFF → ON → OFF,
the difference conversion before Operating condition setting request (Y9) continues and the difference
conversion reference value is not updated. To update the difference conversion reference value, restart the
difference conversion by changing Difference conversion trigger Trigger request (1) → No request (0) →
Trigger request (1) again.
(c) Operation of the maximum value and the minimum value
When the difference conversion starts, the maximum value and the minimum value of the values acquired by
the difference conversion are stored in CH Maximum value and CH Minimum value. By turning on
Maximum value/minimum value reset request (YD), the maximum value and the minimum value after the start
of the difference conversion can be checked.
Trigger request (1)
9950 1300010001 10100 10010 10510 12000 12100 13250 13310
10000 1300010000 10000 10000 10000 10000 10000 10000 13000
001 100 10 510 2000 12100 13250 310
Trigger request (1)No request (0)
Converting difference (1) Converting difference (1)
Not converted (0)
Scaling value
(digital operation value)
CH Difference conversion
reference value
(Un\G180 to Un/G183)
CH Difference conversion
status flag
(Un\G190 to Un\G193)
CH Scaling value
(digital operation value)
(Un\G54 to Un\G57)
CH Difference conversion
trigger (Un\G172 to Un\G175)
Operating condition setting
completed flag (X9)
Operating condition setting
request (Y9)
ON
ON
OFF
OFF
Updated
Not updated
No request (0) Trigger request (1)
9950 995010001 10000 10210 10510 12000 12100 13250 10100
0 100000 10000
10000 10000
10000
10000
10000
10000
9950 -5010001
0
210 510 2000 2100 3250 100
Converting difference (1)Not converted (0)
Scaling value
(digital operation value)
10001 325010001 10001 10001 10001 10001 2100 3250 3250
CH Maximum value
(Un\G30, Un\G32,
Un\G34, Un\G36)
600 -50600 0 0
0
0
2100 2100 -50
CH Minimum value
(Un\G31, Un\G33,
Un\G35, Un\G37)
CH Difference conversion
reference value
(Un\G180 to Un/G183)
CH Difference conversion
status flag
(Un\G190 to Un\G193)
CH Scaling value
(digital operation value)
(Un\G54 to Un\G57)
CH Difference conversion
trigger (Un\G172 to Un\G175)
Maximum value/minimum value
reset completed flag (XD)
Maximum value/minimum
value reset request (YD)
ON
ON
OFF
OFF
Maximum value/minimum value
before starting difference conversion
Maximum value/minimum value
after starting difference conversion

Mitsubishi L Series Specifications

General

Brand	Mitsubishi
Model	L Series
Category	Engine
Language	English